low latency??

I had a slight delay in my headphone mix due to latency. I enabled the low latency monitoring and that got rid of the delay, but it also mutes your plug in effects. How can you get reverb to the monitor headphones?? Any help would be appreciated.

I am in a similar boat. I can't figure out the plugin muting issue w/ low latency monitoring. It seems like it does it sometimes and not others. Anyone know the rhyme or reason as to why a plug gets muted? Does it depend on when you create the instance of the plug? Thanks Chris

What hardware are you using? On the Mbox you mute the track you are recording on so you only hear the input of the vocal and it isn't mixed with the playback from Pro Tools. If you bus the signal to an aux track and make sure the send is prefader then it still gets sent to the aux track even though the audio track is muted. On that aux track you have a reverb plug-in, but make sure that it is 100% wet so you only hear the reverb and not the original signal coming through. There is a delay on the reverb, but it doesn't matter because reverb usually has predelay settings anyway. So you only hear the original signal direct without it going into PT and the reverb comes back from PT with a slight delay. You control the amount of reverb using the fader on the aux track. Is this what you were talking about?

Low latency monitoring diasables all inserts, sends and the audio tracks outputs must be sent to an output and not a bus 2- In setups - playback engine - hardware buffer - set latency to 128 or 256 and latency should not be audible