192 I/O: Calibration not working?

Re: 192 I/O: Calibration not working? 

I tried to go for -14 at one point. One or two channels just wont go that far. -15 is the best you're likely to get. I also found the calibration experience tricky on the 192, because what with my extra output card and the 'b' settings, there are a lot of little screws. I was turning the wrong ones half the time!

Re: 192 I/O: Calibration not working? 

There's been threads on this subject and Digi was suppose to come up with a fix......???? Don't hold your breath!!!

Re: 192 I/O: Calibration not working? 

Since my post has been deleted by Digi let me post again about how Digi was suppose to fix this problem some time ago but never happened. Don't hold your breath! Digi= censorship

Re: 192 I/O: Calibration not working? 

You know I remember reading that the 192s couldn't be calibrated to -14dBfs a while back. But, we just rewired one of our studios and we decided to recalibrate all of our I/O...We were able to cal to -14 without a problem *shrug*. Don't know what's up with that. Anyway, if you keep turning and turning the screw and nothing is changing then it might be defective. Just double check to make sure you were turning the correct screw for the correct I/O and you weren't turning the output screw instead of input or vice versa. Also check the manual to make sure you are going throught the calibration mode correctly. But, it sounds like a defective unit from what you've mentioned.

Re: 192 I/O: Calibration not working? 

oh yeah, another thing to try... cal channels 2-8 and see if they work or if the same thing happens.